Follow Discord
Sweep 06 Nov 2026 · 01:32Z Build v2.1.319 537 read Stable v2.1.311 Latest v2.1.319 Next v2.1.319 Feeds RSS JSON llms.txt llms-full.txt Unofficial
HomeDocsClaude Code CLI 12 Sep 2026
One change · claude-code

Configure your terminal for Claude Code changedterminal-config

Nearest release: v2.1.269, published 8 hours before this site recorded the change. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.

Recorded here
Lines+8added
Lines−7removed
From line 20 where the diff opens
First seen 14 Aug 2026 this site's first read of the page
Recorded edits33to this page, all time

The whole hunk

from line 20, old and new numbered
/
lines
from line 20
2020 
2121In most terminals you can also press Shift+Enter, but support varies by terminal emulator:
2222 
23| Terminal | Shift+Enter for newline |
24| :---------------------------------------------------------------------- | :------------------------------------------ |
25| Ghostty, Kitty, iTerm2, WezTerm, Warp, Apple Terminal, Windows Terminal | Works without setup |
26| VS Code, Cursor, Devin Desktop, Alacritty, Zed | Run `/terminal-setup` once |
27| gnome-terminal, JetBrains IDEs such as PyCharm and Android Studio | Not available; use Ctrl+J or `\` then Enter |
23| Terminal | Shift+Enter for newline |
24| :------------------------------------------------------------------------------------------------- | :---------------------------------------------------------- |
25| Ghostty, Kitty, iTerm2, WezTerm, Warp, Apple Terminal, Windows Terminal | Works without setup |
26| Other terminals that support the kitty keyboard protocol, such as foot and Alacritty 0.16 or later | Works without setup. Requires Claude Code v2.1.269 or later |
27| VS Code, Cursor, Devin Desktop, Alacritty before 0.16, Zed | Run `/terminal-setup` once |
28| gnome-terminal, JetBrains IDEs such as PyCharm and Android Studio | Not available; use Ctrl+J or `\` then Enter |
2829 
29For VS Code, Cursor, Devin Desktop, Alacritty, and Zed, `/terminal-setup` writes a Shift+Enter keybinding into the terminal's configuration file. On the first run you see a confirmation such as `Installed VSCode terminal Shift+Enter key binding`. Existing bindings are left in place; if you see a message such as `VSCode terminal Shift+Enter key binding already configured`, no change was made. Run `/terminal-setup` directly in the host terminal rather than inside tmux or screen, since it needs to write to the host terminal's configuration.
30For VS Code, Cursor, Devin Desktop, Alacritty before 0.16, and Zed, `/terminal-setup` writes a Shift+Enter keybinding into the terminal's configuration file. On the first run you see a confirmation such as `Installed VSCode terminal Shift+Enter key binding`. Existing bindings are left in place; if you see a message such as `VSCode terminal Shift+Enter key binding already configured`, no change was made. Run `/terminal-setup` directly in the host terminal rather than inside tmux or screen, since it needs to write to the host terminal's configuration.
3031 
3132In VS Code, Cursor, and Devin Desktop, `/terminal-setup` also updates two editor settings: it sets `terminal.integrated.gpuAcceleration` to `"off"` to prevent garbled text in the integrated terminal, and it sets `terminal.integrated.mouseWheelScrollSensitivity` for smoother scrolling in [fullscreen mode](/docs/en/fullscreen). To undo the GPU acceleration change, set it back to `"auto"` and reload the editor window.
3233 
Feedback