Continue local sessions from any device with Remote Control changedremote-control
Nearest release: v2.1.321, published 2 hours before upstream edited the page. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.
Upstream edited this page at 9 Nov 2026 21:41 UTC, give or take a minute or two: the time comes from Anthropic’s own sitemap rather than from a commit. This site recorded the change at 9 Nov 2026 22:07 UTC.
Upstream edited
Recorded here
Lines+2added
Lines−0removed
From line
45
where the diff opens
First seen
14 Aug 2026
this site's first read of the page
Recorded edits77to this page, all time
The whole hunk
from line 45, old and new numbered
/
from line 45
4545> claude remote-control
4646> ```
4747>
48> `claude rc` is an alias for this command.
49>
4850> Until you accept Remote Control's one-time confirmation, `claude remote-control` explains what it does and asks `Enable Remote Control? (y/n)` before starting the server. Answer `y` to accept and start the server. If you decline, Claude Code exits without starting the server and asks again the next time you run the command.
4951>
5052> The process stays running in your terminal in server mode, waiting for remote connections. It displays a URL you can use to [connect from another device](#connect-from-another-device), and you can press spacebar to show a QR code for quick access from your phone. While a remote session is active, the terminal shows connection status and tool activity.
No line in this hunk matches that.