Follow Discord
Sweep 03 Nov 2026 · 22:27Z Build v2.1.318 536 read Stable v2.1.311 Latest v2.1.318 Next v2.1.318 Feeds RSS JSON llms.txt llms-full.txt Unofficial
HomeDocsClaude Code CLI 4 Nov 2026
One change · claude-code

Continue local sessions from any device with Remote Control changedremote-control

Nearest release: v2.1.318, published 22 hours before upstream edited the page. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.

Upstream edited this page at 4 Nov 2026 19:55 UTC, give or take a minute or two: the time comes from Anthropic’s own sitemap rather than from a commit. This site recorded the change at 4 Nov 2026 20:07 UTC.

Upstream edited
Recorded here
Lines+15added
Lines−0removed
From line 498 where the diff opens
First seen 14 Aug 2026 this site's first read of the page
Recorded edits70to this page, all time

### "working folder not found" ### "The program file this Remote Control started from is gone"

The whole hunk

from line 498, old and new numbered
/
lines
from line 498
498498* Network or proxy issue: a firewall or proxy may be blocking the outbound HTTPS request. Remote Control requires access to the Anthropic API on port 443.
499499* Session creation failed: if you also see `Session creation failed — see debug log`, the failure happened earlier in setup. Check that your subscription is active.
500500 
501### "working folder not found"
502 
503In the terminal running [`claude remote-control`](#start-a-remote-control-session), `Session failed: working folder not found:` followed by a quoted path means a session couldn't start because no folder exists at that path.
504 
505* **The server is still running**: restore the folder and start the session again, or stop the server
506* **The server has exited**: run `claude remote-control` again from a folder that exists
507 
508Before v2.1.318, a session that failed this way showed `Session failed: spawn error:` and an `ENOENT` message that named a program file instead of the missing folder.
509 
510### "The program file this Remote Control started from is gone"
511 
512This warning in the terminal running [`claude remote-control`](#start-a-remote-control-session) means the program file the server started from is missing, and new sessions run the newer version that replaced it. To move the server to that version too, stop it and run `claude remote-control` again. If Claude Code is installed on network storage, restart the server now and follow [Install on network storage](https://code.claude.com/docs/en/setup.md#install-on-network-storage). Otherwise, new sessions start without a restart.
513 
514When the program file is gone and Claude Code finds no newer version to run, new sessions fail. The terminal shows an error such as `Session failed: spawn error:` followed by an `ENOENT` message. Stop the server, [install Claude Code](https://code.claude.com/docs/en/setup.md#install-claude-code) again if `claude` doesn't run in your shell, and run `claude remote-control` again. Before v2.1.318, new sessions failed this way even with a newer version installed.
515 
501516### "Couldn't reconnect to your Remote Control session"
502517 
503518When you resume a conversation with `claude --resume` or `claude --continue`, Claude Code reconnects to the Remote Control session recorded in that conversation. This message means the reconnection failed for a reason that may be temporary, such as a network interruption or a server error, so Claude Code can't confirm whether the remote session still exists.
Feedback