Unclear It is not known where the list of connector names and addresses is sent.
In a remote session (one where CLAUDE_CODE_REMOTE is set), Claude Code can record the web address of each MCP server that came from a connector. MCP servers are add-ons that give Claude extra tools. It then builds a list with each server's name, address and directory entry, cut down to fit a size limit.
This only happens when a remotely controlled switch is on. The flag server returned it on for this site's account and off for the anonymous baseline, and it was first seen on 2026-11-09. No reading has been taken under this release yet.
It is being rolled out quietly and only for remote sessions, so local use of Claude Code is not affected.
tengu_lazy_spindle Off by default, switched on for this accountThe shipped code defaults this off, and the flag server returned on for the one account this site reads on this version. That is the reading that makes the entry above worth a second look, and it still says nothing about your account.
This account: on · anonymous baseline: off · compiled default in v2.1.321: off
These values were read against a different version of Claude Code, so treat them as the nearest reading available instead of one taken on this release.
Read once, for one account on one subscription tier, against v2.1.321. It isn't a statement about your account. What a flag value here can and cannot tell you
It is not known where the list of connector names and addresses is sent.
New in this build: tengu_lazy_spindle