Follow Discord
Sweep 10 Nov 2026 · 02:18Z Build v2.1.322 539 read Stable v2.1.311 Latest v2.1.322 Next v2.1.322 Feeds RSS JSON llms.txt llms-full.txt Unofficial
HomeDocsClaude Code CLI 10 Sep 2026
One change · claude-code

Fullscreen rendering changedfullscreen

Nearest release: v2.1.268, published 2 hours before this site recorded the change. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.

Recorded here
Lines+1added
Lines−1removed
From line 163 where the diff opens
First seen 14 Aug 2026 this site's first read of the page
Recorded edits31to this page, all time

The whole hunk

from line 163, old and new numbered
/
lines
from line 163
163163 
164164A value of `3` matches the default in `vim` and similar applications. The setting accepts any positive value up to 20, including fractional values below 1 such as `0.25` to slow accelerated trackpad and wheel scrolling in terminals that already amplify wheel events.
165165 
166To adjust scroll speed interactively, run `/scroll-speed`. The dialog shows a ruler you can scroll while it is open so you can feel the change immediately. Press `←` and `→` to adjust the speed, `r` to reset to the auto-detected default, and `Enter` to save. The dialog steps in whole numbers up to 10, and on terminals that support finer control it also offers quarter steps down to 0.25. Quarter steps require Claude Code v2.1.172 or later.
166To adjust scroll speed interactively, run `/scroll-speed`. The dialog shows a ruler you can scroll while it is open so you can feel the change immediately. Press `←` and `→` to adjust the speed, `r` to reset to the auto-detected default, and `Enter` to save. The dialog steps in whole numbers up to 10, and on terminals that support finer control it also offers quarter steps down to 0.25.
167167 
168168The command writes the same value the `CLAUDE_CODE_SCROLL_SPEED` environment variable sets, persisted to `~/.claude/settings.json`. The dialog's maximum is 10: if you set a higher value through the environment variable, the dialog shows 10, and saving from the dialog persists 10. The command isn't available in the JetBrains IDE terminal.
169169 
Feedback