Configure your terminal for Claude Code changedterminal-config
Nearest release: v2.1.304, published an hour after upstream edited the page. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.
Upstream edited this page at 19 Oct 2026 18:23 UTC, give or take a minute or two: the time comes from Anthropic’s own sitemap rather than from a commit. This site recorded the change at 19 Oct 2026 18:37 UTC.
Upstream edited
Recorded here
Lines+1added
Lines−1removed
From line
50
where the diff opens
First seen
14 Aug 2026
this site's first read of the page
Recorded edits25to this page, all time
The whole hunk
from line 50, old and new numbered
/
from line 50
5050
5151 If you accepted Claude Code's first-run terminal setup prompt, this is already done. That prompt runs `/terminal-setup` for you, which enables Option as Meta and turns off the audible bell in your Apple Terminal profile.
5252
53 In [screen reader mode](/docs/en/accessibility), `/terminal-setup` leaves the bell setting unchanged so the terminal bell stays audible. Before v2.1.211, `/terminal-setup` turned the bell off even in screen reader mode. If an earlier run turned the bell off, turn it back on under Settings → Profiles → Advanced → "Audible bell".
53 In [screen reader mode](/docs/en/accessibility), `/terminal-setup` leaves the bell setting unchanged so the terminal bell stays audible. If an earlier run turned the bell off, turn it back on under Settings → Profiles → Advanced → "Audible bell".
5454 </Tab>
5555
5656 <Tab title="iTerm2">
No line in this hunk matches that.