Follow Discord
Sweep 22 Oct 2026 · 04:32Z Build v2.1.308 527 read Stable v2.1.308 Latest v2.1.308 Next v2.1.308 Feeds RSS JSON llms.txt llms-full.txt Unofficial
HomeDocsClaude Documentation 16 Oct 2026
One change · claude-docs

Run on a remote Linux server changedclaude-science/run-on-remote-linux-server

Nearest release: v2.1.302, published under an hour before upstream edited the page. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.

Upstream edited this page at 16 Oct 2026 17:19 UTC, give or take a minute or two: the time comes from Anthropic’s own sitemap rather than from a commit. This site recorded the change at 16 Oct 2026 17:37 UTC.

Upstream edited
Recorded here
Lines+1added
Lines−0removed
From line 111 where the diff opens
First seen 14 Aug 2026 this site's first read of the page
Recorded edits10to this page, all time

The whole hunk

from line 111, old and new numbered
/
lines
from line 111
111111| Interactive HTML previews render as static snapshots after a short delay (charts don't respond) | The tunnel isn't forwarding the preview port. Add the second `-L` forward for the preview port that `claude-science url` prints (8001 by default), with that number on both sides. |
112112| The browser can't reach `localhost:8000` | The tunnel isn't up; rerun the `ssh -L` command. If the tunnel is up, confirm Claude Science is running on the server with `claude-science status`. |
113113| The installer reports no binary for your platform | Claude Science on Linux needs x64 with glibc. arm64 servers and musl-based distributions such as Alpine aren't supported. |
114| The installer stops with a message mentioning `was NOT installed` | Claude Science was already installed on the server, so the installer first tried to check that the new version starts there. The check didn't succeed, so nothing was replaced. The message and the lines under it say why and, where there is a fix, what to do. If they point to the [configuration file](/docs/claude-science/configuration-file-reference), `~/.claude-science/config.toml`, fix what they report in that file, then run the installer again as shown in [Install Claude Science](#install-claude-science). Otherwise, keep using the copy you already had. |
114115 
Feedback