Continue local sessions from any device with Remote Control changedremote-control
Nearest release: v2.1.293, published under an hour after upstream edited the page. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.
Upstream edited this page at 7 Oct 2026 16:29 UTC, give or take a minute or two: the time comes from Anthropic’s own sitemap rather than from a commit. This site recorded the change at 7 Oct 2026 16:37 UTC.
Upstream edited
Recorded here
Lines+1added
Lines−1removed
From line
333
where the diff opens
First seen
14 Aug 2026
this site's first read of the page
Recorded edits53to this page, all time
The whole hunk
from line 333, old and new numbered
/
from line 333
333333## Limitations
334334
335335* **One remote session per interactive process**: outside of server mode, each Claude Code instance supports one remote session at a time. Use [server mode](#start-a-remote-control-session) to run multiple concurrent sessions from a single process.
336* **Local process must keep running**: Remote Control runs as a local process. If you close the terminal, quit the Desktop app or VS Code, or otherwise stop the `claude` process, the session goes offline until you [bring it back](#resume-sessions-after-stopping-the-server). To keep a session running on a remote machine after you disconnect from SSH, start it inside `tmux` or `screen`.
336* **Local process must keep running**: Remote Control runs as a local process. If you close the terminal, quit the Desktop app or VS Code, or otherwise stop the `claude` process, the session goes offline until you [bring it back](#resume-sessions-after-stopping-the-server). If you run `claude` from a terminal on a remote machine, start it inside `tmux` or `screen` to keep the session running after you disconnect from SSH.
337337* **Crashed sessions in server mode**: if a session served by `claude remote-control` crashes, send it a message from a connected device. Claude Code serves it again. You don't have to restart the server. Requires Claude Code v2.1.238 or later.
338338* **HTTP 403 refusals on a connected session**: once an interactive session is connected, Claude Code keeps retrying for up to three minutes when something between your machine and Anthropic's servers answers with HTTP 403, as can happen after a VPN or network change. If the refusals last longer, Claude Code disconnects, and the reason names what refused: a network edge, or a proxy, VPN, or firewall on your own network.
339339* **Extended network outage**: if your machine is awake but can't reach the network, what you do next depends on the mode:
No line in this hunk matches that.