Follow Discord
Sweep 02 Oct 2026 · 18:55Z Build v2.1.288 509 read Stable v2.1.285 Latest v2.1.288 Next v2.1.288 Feeds RSS JSON llms.txt llms-full.txt Unofficial
HomeDocsClaude Code CLI 2 Oct 2026
One change · claude-code

Interactive mode changedinteractive-mode

Nearest release: v2.1.287, published 7 hours before upstream edited the page. Shown because the two are within 24 hours of each other. Nothing here says the release caused the edit.

Upstream edited this page at 2 Oct 2026 00:28 UTC, give or take a minute or two: the time comes from Anthropic’s own sitemap rather than from a commit. This site recorded the change at 2 Oct 2026 00:37 UTC.

Upstream edited
Recorded here
Lines+1added
Lines−1removed
From line 346 where the diff opens
First seen 14 Aug 2026 this site's first read of the page
Recorded edits53to this page, all time

The whole hunk

from line 346, old and new numbered
/
lines
from line 346
346346* Exit with `Escape`, `Backspace`, or `Ctrl+U` on an empty prompt
347347* Pasting text that starts with `!` into an empty prompt enters shell mode automatically, matching typed `!` behavior
348348 
349Unless your session is one of those listed under [strict sandbox mode](/docs/en/sandboxing#the-unsandboxed-retry-escape-hatch), commands you type in shell mode run outside the [sandbox](/docs/en/sandboxing) even when you've enabled sandboxing, because the sandbox applies to the commands Claude runs.
349Unless your session is one of those listed under [strict sandbox mode](/docs/en/sandboxing#turn-off-the-retry-with-strict-sandbox-mode), commands you type in shell mode run outside the [sandbox](/docs/en/sandboxing) even when you've enabled sandboxing, because the sandbox applies to the commands Claude runs.
350350 
351351Claude responds to the command output automatically once it lands in the transcript, so you can run `! npm test` and get an explanation of the failures without a second prompt. The response costs the same as sending a normal prompt. To restore the earlier behavior where the output is added to context without a response, set [`respondToBashCommands`](/docs/en/settings-reference#respondtobashcommands) to `false` in `settings.json`. Before v2.1.186, shell mode always added output to context without a response.
352352 
Feedback