{"version":"2.1.318","anchor":"auto-mode-denies-unapproved-hosts-with-an-explicit-message","canonical_anchor":"auto-mode-denies-unapproved-hosts-with-an-explicit-message","heading":"Auto mode explains why a network host was blocked and how to allow it","tier":"notice","area":"Sandbox","scope":"individual","heads_up":false,"url":"https:\/\/changelogs.core-directive.com\/v\/2.1.318\/e\/auto-mode-denies-unapproved-hosts-with-an-explicit-message","release_url":"https:\/\/changelogs.core-directive.com\/v\/2.1.318","markdown":"### Auto mode explains why a network host was blocked and how to allow it\n\nWhen auto mode blocks an unapproved network host, Claude is told why, not to retry, and that you can allow it in sandbox network settings\n\n**What**\n\nAuto mode is the permission mode where Claude Code goes ahead with actions without asking you each time. The sandbox is the restricted environment that limits which network hosts (addresses on the internet) a command can reach. When a host is blocked because no one approved it, Claude Code now gives a specific reason. It says no one approved this host, and that auto mode does not check hosts in this session. It tells Claude not to retry during this turn, and says you can allow the host in your sandbox network settings.\n\n**Why**\n\nBoth Claude and you get clearer feedback when a network request is blocked, and you know where to go to allow the host.\n\n- Area: Sandbox\n- Tier: You'll notice\n- Useful: 2\/5\n- Signal: 1\/5\n- Scope: individual\n- Heads-up: no"}