{"version":"2.1.290","anchor":"fig-autocomplete-spec-loading-gated-by-tengu-keen-anchor","canonical_anchor":"fig-autocomplete-spec-loading-gated-by-tengu-keen-anchor","heading":"Shell completion data may stop loading in packaged installs, behind a server switch","tier":"notice","area":"Shell","scope":"individual","heads_up":false,"url":"https:\/\/changelogs.core-directive.com\/v\/2.1.290\/e\/fig-autocomplete-spec-loading-gated-by-tengu-keen-anchor","release_url":"https:\/\/changelogs.core-directive.com\/v\/2.1.290","markdown":"### Shell completion data may stop loading in packaged installs, behind a server switch\n\nWhen a server switch is on, Claude Code loads shell command completion data only when run from source, skipping it in packaged installs\n\n**Unclear.** Which kinds of installation are affected is not settled.\n\n**What**\n\nClaude Code uses completion data from `@withfig\/autocomplete` to know about shell commands and their options. Loading it now depends on a server-controlled switch. When the switch is on, the data loads only when Claude Code runs directly from its source files, so compiled or bundled installs skip it. When it is off, the older check applies. The built-in fallback for the switch is on.\n\n**Why**\n\nShell command completion data may stop loading in packaged builds of Claude Code.\n\n- Flag `tengu_keen_anchor`: Not enough to say (read for one account on one subscription tier against v2.1.290; this account: no value returned, anonymous baseline: no value returned, compiled default: on) These values were read against a different version of Claude Code, so treat them as the nearest reading available instead of one taken on this release.\n- Area: Shell\n- Tier: You'll notice\n- Useful: 1\/5\n- Signal: 2\/5\n- Scope: individual\n- Heads-up: no"}