{"version":"2.1.284","anchor":"auto-mode-setup-checks-login-before-scanning-with-new-erro","canonical_anchor":"auto-mode-setup-checks-login-before-scanning-with-new-erro","heading":"\/auto-mode-setup checks you are signed in before it scans your environment","tier":"notice","area":"Auto Mode","url":"https:\/\/changelogs.core-directive.com\/v\/2.1.284\/e\/auto-mode-setup-checks-login-before-scanning-with-new-erro","release_url":"https:\/\/changelogs.core-directive.com\/v\/2.1.284","markdown":"### `\/auto-mode-setup` checks you are signed in before it scans your environment\n\n`\/auto-mode-setup` now checks your login first and tells you to run `\/login` if it has expired or you are not signed in\n\n**Unclear.** It is not clear whether the login check applies in every environment, since part of the condition that triggers it was not identified.\n\n**What**\n\n`\/auto-mode-setup` drafts auto mode settings by scanning your project and recent sessions. Before that scan, it now checks that you are signed in. If the check fails, setup stops and tells you to run `\/login` and then run `\/auto-mode-setup` again. It reports whether the login has expired or you are not signed in at all.\n\nThe check passes when an API key or an `apiKeyHelper` is set up.\n\n**Why**\n\nIf your login has expired, you now get a clear instruction instead of a scan that fails for no obvious reason.\n\n- Area: Auto Mode\n- Names: `\/auto-mode-setup`, `\/login`\n- Tier: You'll notice\n- Useful: 2\/5\n- Signal: 1\/5"}