{"version":"2.1.283","anchor":"claude-daemon-help-lists-remote-control-listaddremove-subc","canonical_anchor":"claude-daemon-help-lists-remote-control-listaddremove-subc","heading":"Remote Control servers under claude daemon split out from the rest of the daemon","tier":"notice","area":"Background Daemon","url":"https:\/\/changelogs.core-directive.com\/v\/2.1.283\/e\/claude-daemon-help-lists-remote-control-listaddremove-subc","release_url":"https:\/\/changelogs.core-directive.com\/v\/2.1.283","markdown":"### Remote Control servers under claude daemon split out from the rest of the daemon\n\nclaude daemon remote-control now has its own availability check, help for list\/add\/remove, and an extra precondition check before trusting a directory\n\n**Unclear.** It is not certain which remote setting decides whether the Remote Control help section is shown.\n\n**What**\n\n`claude daemon` manages a background service that runs Claude Code work for you. Its subcommands were all refused behind one switch. Remote Control now has its own path.\n\n- `claude daemon remote-control` now has a separate availability check. It can pass when the remote flag `tengu_radiant_heron` is on. `list`, `scheduled` and `hub` still exit with \"is not available in this environment\".\n\n- `claude daemon` help gains a Remote Control servers section, shown only when Remote Control is allowed. It lists: `remote-control list [--json]`\n\n- `remote-control add [--dir <path>] [--name <n>] [--spawn-mode same-dir|worktree]`\n\n- `remote-control remove <name-or-dir>`\n\n- The help notes that add and remove require the service to be installed.\n\n- The remote-control server command now runs an extra check before it resolves `--dir` and checks whether the folder is trusted. If that check returns a reason, the command exits with it, except under one condition.\n\n- `claude daemon status` prints extra lines about served folders, and worker status reports a `servedFolder` with its folder and session count.\n\n**Why**\n\nRemote Control under the daemon can now be switched on without the rest of the daemon. The commands for adding and removing Remote Control servers are documented in the help. The server command may now refuse earlier than before, with a new reason.\n\n- Flag `tengu_radiant_heron`: Off in both readings (read for one account on one subscription tier against v2.1.283; this account: off, anonymous baseline: off, compiled default: off) These values were read against a different version of Claude Code, so treat them as the nearest reading available instead of one taken on this release.\n- Area: Background Daemon\n- Names: `claude daemon`\n- Tier: You'll notice\n- Useful: 4\/5\n- Signal: 4\/5\n- Present in the build but not switched on"}